Premium Carbon Fiber Shaft for Minelab Equinox 800/600 Metal Detector - Lightweight & Durable Replacement Part for Treasure Hunting & Beach Metal Detecting

Stork Carbon Fiber Shaft for Minelab EquinoxGlides through the water like you have never experienced.Light, strong and rigidOnly .40 poundsBolts (for maximum rigidity) directly to your Equinox 600 or 800 with the supplied Stainless screws, with our without the plastic knobs.Included are colored knobs/screws which you might like. Yellow is a 6mm and screws the upper handle and the red is 1/4-20 for the mid-shaft. Be sure not to mix up the screws: The finer thread 6mm screws for the upper connection and the 1/4 course thread for the midsection.The lower teardrop-shaped rubber washers are larger than the original Minelab. 2 spare washers are supplied in case you wear the original set out in a year or two.You should use your original coil screw and nut but we have included a spare nylon screw and wing nut just incase.Carbon Fiber Mid and Lower shaftA premium roll of 3M black tape is included so you can seal all holes and joints so sand will not enter and freeze up your shafts.The Mid shaft is 3/4" diameter, smaller than the 20mm originalThe lower shaft is 10mm diameter (just over 3/8")We provide a 3-year warranty if you seal all holes and joints with black electrical tape (supplied) so sand will stay out of the joints.MADE IN THE USA